MSP430G2433IRHB32T

The MSP430G2433IRHB32T is a 16-bit ultra-low-power Mixed-signal Microcontroller features a powerful 16-bit RISC MSP430 CPU, 16-bit registers and constant generators that contribute to maximum code efficiency. The architecture combined with five low-power modes, is optimized to achieve extended battery life. The digitally controlled oscillator (DCO) allows wake-up from low-power modes to active mode in less than 1µs. The device configurations with two 16-bit timers, 10-bit A/D converter, built-in communication capability using the USCI and 24 general-purpose I/O pins. This device operates at a maximum frequency of 16MHz.

• 16-bit RISC architecture, 62.5ns instruction cycle time
• Internal frequencies up to 16MHz with four calibrated frequencies
• Internal very-low-power low-frequency oscillator
• 32kHz Crystal
• External digital clock source
• Two 16-bit Timer_A with 3 Capture/Compare registers
• Up to 24 Capacitive-touch enabled I/O pins
• Enhanced UART supports automatic baud-rate detection (LIN)
• IrDA Encoder and decoder
• Synchronous SPI
• 10-bit 200ksps ADC with internal reference, sample-and-hold and autoscan
• Brownout detector
• Serial on-board programming
• No external programming voltage needed
• Programmable code protection by security fuse
• On-chip emulation logic with spy-bi-wire interface
• Summarizes available family members
• 230µA at 1MHz, 2.2V Active mode (AM) power consumption

Tillämpningar

Portable Devices, Test & Measurement, Sensing & Instrumentation, Power Management